Truck Bumpers & Winches in Washington, UT
Front and rear bumpers, winch mounting and recovery wiring for trucks, Jeeps and Broncos.
MST Motorsports provides professional bumper and winch installation for trucks, Jeeps and Broncos in Washington, Utah, including front and rear bumpers, tire carriers, hidden winch mounts and bull bars. Steel and aluminum are both available, and the choice comes down to weight and approach angle.
A steel bumper adds weight over the front axle, so ride height and front spring rate are checked after installation. A leveling kit or a heavier coil often accompanies a full plate bumper, and the geometry is measured before and after so it stays within specification.
Our factory-trained, certified technicians wire every winch on fused cable with a disconnect near the battery, mount the solenoid away from heat and water, set the fairlead and spool the rope under load.
Brands in this category include Warn, Smittybilt, Body Armor, Fab Fours, ARB and Road Armor. We also install and service Superwinch and WARN winches, Factor 55 recovery hardware, and bumpers and armor from Addictive Desert Designs, Ranch Hand, Hammerhead Armor, DV8 Offroad and Rugged Ridge. Bumpers, armor and winches are installed on trucks, Jeeps, Broncos and SUVs. The brands listed here are a portion of what we install. Call or text (435) 256-8899 with the brand you want, and we will source it or recommend a comparable bumper or winch rated for your vehicle weight.
Recovery Gear for Southern Utah Trails
A rated recovery point on a properly mounted bumper turns a stuck truck at Sand Hollow or on the trails past Hurricane into a straightforward pull.
Our shop is at 987 S 1900 East in Washington. Schedule online, or call or text (435) 256-8899.
Frequently Asked Questions
Do you install winches on trucks and Jeeps?
Yes. Winches are mounted on bumper plates or hidden mounts, wired to the battery through a fused disconnect, fitted with the fairlead and rope, and load-tested after installation.
Will an aftermarket bumper affect my parking sensors or camera?
Steel bumpers change sensor angles and camera housings on late-model trucks, and many include relocation cutouts for the factory hardware. Our technicians transfer the sensors and verify their readings after installation.
What winch capacity should I run?
A common starting point is roughly one and a half times the loaded weight of the vehicle, with heavier trucks and mud recovery calling for more. Call (435) 256-8899 with your truck and typical terrain and we will size the winch.
How much does a bumper and winch install cost?
Cost depends on the bumper material, the winch capacity and the wiring involved. Call (435) 256-8899 for a quote on your vehicle.
Book Service
Schedule your bumper and winch installation online, or call or text (435) 256-8899 with the vehicle and the recovery work you have in mind.